Uderc programming article aggregator sites

I/o set to ttya in v880 and not taking commands from 25 pin serial cable

Answers: Have 3 answers
it shows all info from hyper terminal via 25 pin cable but i m not able to give commands from it
The best answer: Hello,
is this a known good cable (is/was working with other systems) ?
Have you verified the settings in the terminal emulation (Hyperterm) ?
This is either a wiring issue (hardware) or wrong handshaking (software).
Use 9600,8,N,1 and no flow-control. This is my current setup with TeraTerm.
Btw. no need to double-post